usb-enable (profile/device-config-mode-commands)

Profile Config Commands

Enables or disables the USB port on one or more APs. By default, USB ports are enabled. This command is also applicable to the device configuration mode.

Supported on the following platforms

• Access Points: AP505, AP510, AP510i-1, AP410, AP410i-1, AP310, AP310i/e-1, AP410C, AP410C-1, AP5010, AP3000, AP305C, AP305C-1, AP305CX, AP302W
• Service Platforms: NX5500, NX7500, NX9500, NX9600
• Virtual Platforms: CX9000, VX9000

Syntax Profile Mode

vx9000-C004BA(config-profile-default-ap410-1)#usb-enable

vx9000-C004BA(config-profile-default-ap410-1)#no usb-enable

Syntax Device Mode

vx9000-C004BA(config-device-00-DC-B2-3C-C5-1C)#usb-enable

vx9000-C004BA(config-device-00-DC-B2-3C-C5-1C)#no usb-enable 

Related Commands